Weider Pro 9730 English Manual - Page 13
Attach the High Cable 23 to a Small U
View all Weider Pro 9730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
23. Attach the High Cable (23) to a Small "U"- 23 Bracket (67) with a 1/4" Nylon Locknut (2) and a 1/4" Washer (10). Do not completely tighten the Nylon Locknut. It should be threaded onto the end of the Cable only a couple of turns, as shown in the inset drawing. 24. Locate the Press Cable (58). Attach the Press Cable to the Rear Upright (56) with a 5/16" x 3" Bolt (93), a 5/16" Washer (8), and two 5/16" Nylon Jam Nuts (84). The end of the Cable must be between the two Nylon Jam Nuts and there must be enough room between the Nylon Jam Nuts for the end of the Cable to pivot. Wrap the Press Cable (58) around a 3 1/2" Pulley (15). Attach the Pulley and a Cable Trap (66) to the Squat Arm (79) with a 3/8" x 3 3/4" Bolt (71), a 3/8" Washer (9), and a 3/8" Nylon Locknut (21). The Cable Trap must be turned to hold the Cable in place. 25. Attach the end of the Press Cable (58) to the Long "U"-Bracket (57) with a 1/4" Nylon Locknut (2) and a 1/4" Washer (10). Do not completely tighten the Nylon Locknut. It should be threaded onto the end of the Cable so only a couple of threads are showing above the nut, as shown in the inset drawing. 23 10 2 67 24 79 58 15 66 71 84 25 23 67 10 2 21 9 93 8 56 CABLE ASSEMBLY 58 10 2 57 13 58 57 10 2