Weider Pro 9730 English Manual - Page 14
Pulley 15. Attach the Pulley and a Cable
View all Weider Pro 9730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
26. Attach the 3 1/2" Low Pulley (88) and the 5/8" 26 x 9/16" Spacer (73) to the indicated hole in the Press Frame (17) with a 3/8" x 3 3/4" Bolt (71), and a 3/8" Washer (9). Be sure that the 3/8" x 3 3/4" Bolt (71), the 3/8" Washer (9), the 5/8" x 9/16" Spacer (73), the 3 1/2" Low Pulley (88), and the 3/8" Nylon Locknut (21) are oriented as shown. CABLE ASSEMBLY 9 71 17 73 88 27. Locate the Low Cable (86). Slide the Low 27 Cable into place under the 3 1/2" Low Pulley (88). Be sure that the end of the Cable with the ball is on the indicated side of the Press Frame (17) and that the Cable is between the Pulley and the crossbar on the Press Frame. Fully tighten a 3/8" Nylon Locknut (21) onto the 3/8" x 3 3/4" Bolt (71). Note: You may need to remove the 3 1/2" Low Pulley (88) from the 3/8" x 3 3/4" Bolt (71) to properly route the Low Cable (86). 28. Wrap the Low Cable (86) around a 3 1/2" 28 Pulley (15). Attach the Pulley and a Cable Trap (66) to the lower hole in the Front Upright (42) with a 3/8" x 3 3/4" Bolt (71), a 3/8" Washer (9), and a 3/8" Nylon Locknut (21). Be sure that the Cable Trap is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. 21 86 17 71 88 Ball Crossbar 66 21 86 15 9 42 71 14