Weider Pro 9730 English Manual - Page 16

Insert the Bolt into the Front Base 4.

Page 16 highlights

33. Route the Low Cable (86) over the lower 33 3.1/2" Pulley (15) attached to the "I"-Plates 81 (81). The Cable must be routed from the direction shown. 15 86 CABLE ASSEMBLY 34. Slide a 5/16" Washer (8) onto a 5/16" x 3" Bolt 34 (93). Insert the Bolt into the Front Base (4). Slide theend of the Press Cable (88) onto the Bolt. Fully tighten a 5/16" Nylon Locknut (3) onto the Bolt. Do not overtighten the Nylon Locknut. 35. Attach the Small "U"-Bracket (67) to the indicated Weight Tube (63) a the 5/16" x 1 3/4" 35 Bolt (72) and a 5/16" Nylon Locknut (3). 72 8 93 86 3 4 3 67 63 36. Locate the Rear Cable (95). Attach the Rear Cable to the Rear Base (51) with the 3/8" x 36 3/4" Bolt (24) and a 3/8" Nylon Locknut (21). Route the Rear Cable (95) over the 3 1/2" Pulley (15) attached to the Long "U"-Bracket (57). 16 57 15 24 51 95 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35

33. Route the Low Cable (86) over the lower
3
.
1/2” Pulley (15) attached to the “I”-Plates
(81). The Cable must be routed from the
direction shown.
34. Slide a 5/16” Washer (8) onto a 5/16” x 3” Bolt
(93). Insert the Bolt into the Front Base (4).
Slide theend of the Press Cable (88) onto the
Bolt. Fully tighten a 5/16” Nylon Locknut (3)
onto the Bolt.
Do not overtighten the Nylon
Locknut.
35. Attach the Small “U”-Bracket (67) to the indi-
cated Weight Tube (63) a the 5/16” x 1 3/4”
Bolt (72) and a 5/16” Nylon Locknut (3).
36.
Locate the Rear Cable (95).
Attach the Rear
Cable to the Rear Base (51) with the 3/8” x
3/4” Bolt (24) and a 3/8” Nylon Locknut (21).
Route the Rear Cable (95) over the 3 1/2”
Pulley (15) attached to the Long “U”-Bracket
(57).
36
16
CABLE ASSEMBLY
33
34
93
15
86
86
81
8
4
3
35
67
63
3
72
24
51
15
57
95
21