Weider X2 Uk Manual - Page 10

11. Insert the round tube on the Right Arm (11) into the indicated hole in the Butterfly/Press Frame (9). While a second person holds the Right Arm, place a 25mm Washer (85) over the tube on the Right Arm. Attach the Right Arm with an M6 x 35mm Screw (77) and an M6 Nylon Locknut (79). Press a 25mm Round Inner Cap (41) into the tube on the Right Arm (11). Attach the Left Arm (10, not shown) to the Butterfly/ Press Frame (9) as described in steps 10 and 11. 11 11 77 79 41 85 9 12. Press a 45mm Square inner Cap (38) into the top of the Leg Lever (8). Attach the Bumper (45) to the indicated hole in the Leg Lever (8) with an ST5 x 15mm Screw (82). Lubricate an M10 x 70mm Bolt (57). Attach the Leg Lever (8) to the bracket on the Seat Frame (7) with the Bolt and an M10 Nylon Locknut (60). Do not overtighten the Nylon Locknut; the Leg Lever must pivot easily. 12 38 8 60 7 82 45 Lubricate 57 Cable Assembly 13 13. Open the parts bag labelled "CABLE ASSEMBLY." Refer to the Cable Diagram on page 16 as you assemble the Cables. Identify the Butterfly Cable (47). It has a loop on each end and it is about 271cm long. Wrap the Butterfly Cable around a 90mm Pulley (50) in the direction shown. Attach the Pulley and two Pulley Covers (28) to a Butterfly Pulley Bracket (26) with an M10 x 50mm Bolt (54), an M10 Flat Washer (62), and an M10 Nylon Locknut (60). Make sure that the Pulley Bracket is turned exactly as shown. 14. Lubricate an M10 x 80mm Bolt (56). Attach the 14 Butterfly Pulley Bracket (26) to the indicated bracket on the Front Upright (4) with the Bolt and an M10 Nylon Locknut (60). Make sure that the larger label on the Pulley Covers (28) is facing forward. Slide the loop on the end of the Butterfly Cable (47) onto the welded hook on the semi-circular bracket behind the Left Arm (10). 10 54 62 47 50 28 26 60 Welded Hook 4 56 Lubricate 28 26 10 60 47