Whirlpool KDSS907SSS Installation Instructions - Page 14
wire connection: Power Supply Cord
View all Whirlpool KDSS907SSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Style 2: Direct wire strain relief ■ Remove the knockout as needed for the flexible conduit connection. ■ Assemble a UL listed conduit connector in the opening. A B A. Removable retaining nut B. Strain relief ■ Feed the flexible conduit behind the black horizontal cross brace and through the strain relief, allowing enough slack to easily attach the wiring to the terminal block. A B A. Black horizontal cross brace B. Flexible conduit ■ Tighten strain relief screw against the flexible conduit. 4. Complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if 4-wire is not available) Electrical Connection Options If your home has: And you will be Go to Section: connecting to: 4-wire receptacle (NEMA type 14-50R) A UL listed, 250-volt minimum, 40-amp, range power supply cord 4-wire connection: Power supply cord 4-wire direct 5" (12.7 cm) A fused disconnect or circuit breaker box 4-wire connection: Direct wire 3-wire receptacle (NEMA type 10-50R) A UL listed, 250-volt minimum, 40-amp, range power supply cord 3-wire connection: Power supply cord 3-wire direct 1" (2.5 cm) 3" (7.6 cm) A fused disconnect or circuit breaker box 3-wire connection: Direct wire 4-wire connection: Power Supply Cord Use this method for: ■ New branch-circuit installations (1996 NEC) ■ Mobile homes ■ Recreational vehicles ■ In an area where local codes prohibit grounding through the neutral. 1. Remove the ground-link screw from the range frame. Save the ground link screw and cup washer. Bend the ground-link away from the range so that it does not contact the range. C B A A. Ground-link screw B. Cup washer C. Ground-link bent away from range 2. Connect the green ground wire from the power supply cord to the range using the ground-link screw. The ground wire must be attached first and must not contact any other terminal. 3. Use a ¼" nut driver and remove the hex washer head screws from the terminal blocks. 14