Whirlpool KDSS907SSS Installation Instructions - Page 22
To Convert TripleTier, Flame Burner on some models
View all Whirlpool KDSS907SSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
4. Gas orifice spuds are stamped with a number on the side. Replace the LP gas orifice spud with the correct Natural gas orifice spud. IMPORTANT: The TripleTier® Flame burner has 2 gas orifice spuds. Do not forget to change the external gas orifice spud located under the plate. A XXX A B A. Stamped number Refer to the following chart for the correct Natural gas orifice spud placement. Natural Gas Orifice Spud Chart for Standard Surface Burners Burner Location Burner Rating Size Right front Left front Right rear Left rear 6,000 Btu/h 14,000 Btu/h 12,500 Btu/h 6,000 Btu/h 1.10 mm 1.70 mm 1.61 mm 1.10 mm 5. Place LP gas orifice spuds in plastic parts bag for future use and keep with literature package. 6. Replace burner cap. 7. Repeat steps 1-6 for the remaining burners, except for the TripleTier® Flame burner (on some models). See "To Convert TripleTier® Flame Burners" section. To Convert TripleTier® Flame Burner (on some models) 1. Remove burner cap. 2. Remove the burner head using a size T20 TORX® screwdriver. 3. Remove the plate on the external gas orifice spud. A B C D C A. Plate B. External gas orfice spud C. Internal gas orifice spud 4. Apply masking tape to the end of a 7 mm nut driver to help hold the internal gas orifice spud in the nut driver while changing it. Press nut driver down onto the internal gas orifice spud and remove by turning it counterclockwise and lifting out. Set internal gas orifice spud aside. 5. Use a 7 mm combination wrench to remove the external orifice spud. Turn counterclockwise remove, set external gas orifice spud aside. 6. Replace the LP gas orifice spud with the correct Natural gas orifice spud. Refer to the following chart for correct Natural gas orifice spud placement. Natural Gas Orifice Spud Chart for TripleTier® Flame Burners Burner Location Burner Rating Size Left front (external TripleTier® burner) Left front (internal TripleTier® burner) 12,200 Btu/h 2,800 Btu/h 1.70 mm 0.70 mm 7. Replace burner plate, head and cap. 8. Place LP gas orifice spuds in plastic parts bag for future use and keep with literature package. 9. Reinstall the warming drawer. See the "Replace Oven Racks & Warming Drawer" section for instructions. 10. Complete installation. See "Make Gas Connection" and "Electronic Ignition System" sections. Checking for proper cooktop burner flames is very important. Natural gas flames do not have yellow tips. IMPORTANT: You may have to adjust "LO" setting for each cooktop burner. A. Burner caps B. Burner heads C. External gas orifice spud access plate D. Internal gas orifice spud 22