Whirlpool KDSS907SSS Installation Instructions - Page 15

4. Connect the neutral (center) wire to the center terminal connector using one of the hex washer head screws. Securely tighten screw. E D F C B G H A I 3. Connect the other 2 wires (lines 1 and 2) to the outer terminal screws on the terminal block. 4. Tighten strain relief screws. 5. Replace terminal block cover with screw. Direct Wire Installation: Copper or Aluminum Wire This range may be connected directly to the fuse disconnect or circuit breaker box. Depending on your electrical supply, make the required 3-wire or 4-wire connection. 1. Strip outer covering back 3" (7.6 cm) to expose wires. Strip the insulation back 1" (2.5 cm) from the end of each wire. 1" (2.5 cm) A. Line 1 B. Green ground wire C. Ground-link screw D. Hex washer head screw E. Silver-colored terminal block screw F. Ground-link G. Neutral (center) wire H. Line 2 I. UL listed strain relief and 40-amp range power supply cord 5. Connect the other 2 wires (lines 1 and 2) to the outer aluminum terminal blocks. 6. Securely tighten screws. 7. Tighten strain relief screws. 8. Replace terminal block cover with screw. 3-wire connection: Power Supply Cord Use this method only if local codes permit connecting cabinetground conductor to neutral wire of power supply cord. 1. Use a ¼" nut driver and remove the hex washer head screws from the aluminum terminal blocks. 2. Connect the neutral (center) wire to the center terminal connector using one of the hex washer head screws. Securely tighten screw. D 3" (7.6 cm) 2. Allow enough slack in the wire to easily attach the wiring terminal block. 3. Complete electrical connection according to your type of electrical supply (4-wire or 3-wire connection). 4-wire Connection: Direct Wire Use this method for: ■ New branch-circuit installations (1996 NEC) ■ Mobile homes ■ Recreational vehicles ■ In an area where local codes prohibit grounding through the neutral 1. Remove the ground-link screw from the range frame. Save the ground-link screw and cup washer. Bend the ground-link away from the range so that it does not contact the range. C E B F A G A. Line 1 B. Ground-link C. Hex washer head screw D. Silver-colored terminal block screw E. Neutral (center) wire F. Line 2 G. UL listed strain relief and 40-amp range power supply cord C B A A. Ground-link screw B. Cup washer C. Ground-link bent away from range 15