Whirlpool WEG730H0DS Installation Guide - Page 15

Complete Installation 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Check that you have all of your tools. If range does not operate, check the following: ■ Household fuse is intact and tight, or circuit breaker has not tripped. 3. Check that you have all of the range accessories, especially oven racks. These accessories may be in the range packaging. ■ Gas pressure regulator shutoff valve is in the open position. ■ Range is plugged into a grounded 3 prong outlet. 4. Dispose of/recycle all packaging materials. ■ Electrical supply is connected. 5. Check that the range is level. See the "Level Range" section. 6. Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by shipping material. Dry thoroughly with a soft cloth. For more information, see the "Range Care" section of the User Guide. 9. When the range has been on for 5 minutes, check for heat. If the range is cold, turn off the range and check that the gas supply line shutoff valve is open. ■ If the gas supply line shutoff valve is closed, open it, then repeat the 5-minute test as outlined above. 7. Read the User Guide. 8. Turn on surface burners and oven. See the User Guide for specific instructions on range operation. NOTE: Odors and smoke are normal when the oven is used the first few times. ■ If the gas supply line shutoff valve is open, close it, and contact a qualified technician. If you need Assistance or Service: Please reference the "Warranty" section of the User Guide to contact service. 15