Whirlpool WEG730H0DS Installation Guide - Page 23
Check Operation of Oven Bake Burner, Adjust Oven Bake Burner Flame if needed
View all Whirlpool WEG730H0DS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
To adjust double burner (on some models): 1. Light burner and turn to lowest setting where both inner and outer burners are lit. 2. Remove the control knob. 3. Insert a ¹⁄₈" (3 mm) flat-blade screwdriver into the adjustment locations shown in the following illustration and engage the slotted screw. Turn the screw until the flame is the proper size. Turning the screw clockwise will increase the flame size, and turning the screw counterclockwise will decrease the flame size. A 3. Check the oven bake burner for proper flame. a. Remove the oven racks. b. To remove the oven bottom: Remove 2 screws at the rear of the oven bottom. Lift the rear of the oven bottom up and back until the front of the panel is away from the front frame. Remove from oven and place on a covered surface. A B B C 4. Replace the control knob. 5. Test the flame by turning the control from the low position to the high position, checking the flame at each setting. Check Operation of Oven Bake Burner Refer to the User Guide for proper operation of the oven controls. Adjust Oven Bake Burner Flame (if needed) 1. Remove the premium storage drawer, warming drawer or baking drawer (see the "Remove/Replace Drawer" section). 2. Locate gas pressure regulator at rear of the drawer compartment. NOTE: On models with a warming drawer or baking drawer, an access cover must be removed to access the gas pressure regulator. A A. Screws B. Oven bottom c. Press BAKE. d. Press the start pad. The oven bake burner should light within 8 seconds. Under certain conditions, it may take the burner up to 50 to 60 seconds to light. Electronic igniters are used to light the bake and broil burners. This flame should have a ½" (1.3 cm) long inner cone of bluish-green, with an outer mantle of dark blue, and should be clean and soft in character. No yellow tips, blowing or lifting of flame should occur. 4. If the oven bake flame needs to be adjusted, locate the air shutter near the center rear of the drawer cavity behind the access panel. Loosen the locking screw and rotate the air shutter until the proper flame appears. Tighten locking screw. A B A. Gas pressure regulator IMPORTANT: Do not remove the gas pressure regulator. A. Locking screw B. Air shutter 5. Push the off pad when finished. 6. Reinstall the oven bottom and the premium storage drawer, warming drawer or baking drawer (see the "Remove/Replace Drawer" section). 23