Xerox 3100MFP/S Dect Phone User Guide - Page 32

SETTINGS During the registration process (up to one minute), the LCD screen displays HANDSET REGISTRATION. The message disappears once registration is complete. If the registration process fails (for example, the handset left the registration mode too soon), the machine emits a 3-beep signal. In this case, repeat the procedure from step 1. The new handset and the base are mutually searching for each other. The registration may take several seconds. Once the handset is registered, the handset automatically exits the registration mode and lets you know the registration is done. You can also set your base to the registration mode using a handset already registered by selecting the Registration function in the menu SETTINGS/ADVENCED SET./SET BASE. BASE SETTINGS (TERMINAL) Using a handset to put the base in registration mode This function enables you to put the base in registration mode so you can register a new handset. To do so, the handset to be registered must be in registration mode (refer to paragraph Registering a new handset to a terminal, page 30). On the navigator key , press or until the SETTINGS screen is displayed, press OK to confirm. Select ADVANCED SET. using Press Valid. . or . Select SET BASE using Valid. . or . Press Select REGISTR. MODE using Press Valid. . or . A screen prompts you to confirm the setting of the base to the registration mode. Press Yes to enter the registration mode. The indicator light on your base starts to quickly blink green. Your base will remain in registration mode for about 1 minute. 33