Xerox 3100MFP/S Dect Phone User Guide - Page 34

APPENDIX Care and Maintenance Use a slightly damp cloth to wipe the base and handset, do not use a dry cloth as this may cause electrostatic charges. Problems Refer to the table presented below in case of an operational malfunction: Problems The handset display is blank The handset does not ring during an incoming call No radio link between the handset and base The network indicator icon flashes You obtain a "busy" dial tone for each dialled number Remedies Make sure the batteries are properly installed. Place the handset on the base and fully charge the batteries. To increase the life of your batteries, you can perform this operation about every two months. If these precautionary measures do not resolve this issue, replacement batteries are available through your reseller. As time goes by, you may notice a slight decrease in battery performance. Use your handset until the battery is fully discharged, and then charge it for at least 12 hours. Make sure that the telephone is properly connected and that you have a dial tone. Make sure your telephone is not set to silent mode (see pargraph Settings). Make sure your terminal is in FAX-TEL mode. Make sure the handset is registered by moving closer to the base, if it is registered correctly, the handset screen should display its own handset number. Otherwise, register the handset to the base. See "Registering a new handset to a terminal", page 30. Make sure no one else is using another handset (if the intrusion mode is deactived). 35