Xerox 5400DX Network Guide - Page 19
Windows2000 Network, Introduction, Preliminary steps, Quick install steps (Microsoft TCP/IP
UPC - 042215476539
View all Xerox 5400DX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Windows 2000 Network Introduction Your printer can be installed on a Windows 2000 network using one of three methods: Microsoft TCP/IP protocol Xerox TCP/IP Port Monitor AppleTalk protocol The Preliminary Steps given below must be accomplished for all printers regardless of the method that is being used. Then, the Quick Install Steps detail the installation process corresponding to the method selected. The CentreWare DP program on your Printer Management Software CD-ROM can also be used to monitor and configure the printer. Preliminary steps 1. Print the Configuration Sheet. Details are in this document in Appendix A: Print the Configuration Sheet. Retain this page for reference. 2. Check the Configuration Sheet and verify that both the desired protocol and connector are enabled. 3. Proceed to the Quick Install Steps for the installation method selected. Quick install steps (Microsoft TCP/IP protocol) 1. At the Desktop, right-mouse-click the My Network Places icon and select Properties. 2. Right-mouse-click the Local Area Connection icon inside the Network and Dial-up Connections window. Select Properties. 3. Select the General tab and verify that Internet Protocol (TCP/IP) is loaded. Quick Network Install Guide 13