Yamaha DTXPRESS Owner's Manual - Page 38

Trigger Setup Edit Mode 2. COMMON Parameters Contains common settings for all pad inputs (1-10). This group is divided into the following 3 pages. 2-1. Increment/Decrement 38 2-2. Input Exchange 38 2-3. Trigger Setup Name 38 2-1. Increment/Decrement This sets the pad function that allows the currently selected drum kit number to be increased or decreased by 1 by hitting the specified pad. TRIG Common IncIn= 4DecIn= 5 q w q Incin (Pad for Increment) [Range] -, 1-10 Assigns the trigger input jack number that is set for the increment (+1) function. "--" will appear when this function is not assigned to the pad. w Decin (Pad for Decrement) [Range] -, 1-10 Assigns the trigger input jack number that is set for the decrement (-1) function. "--" will appear when this function is not assigned to the pad. * Even when the drum kit is changed, the pads connected to the assigned trigger input jacks will retain their increment/decrement functions. To assign this function to each drum kit, refer to the Drum Kit Voice Edit mode's [2-6. Function] (P. 44) 2-2. Input Exchange Switches the trigger signal from the pads between trigger input jacks 1 and 9/10. TRIG Common In Excg= normal q q In Excg (Input Exchange) normal: Normal operation. In10,1/9: The signals from Input Jacks 1 and 9/10 are switched. When the input jack 1 pad is hit. m This event will be recognized as a signal from the input jack 10 pad (as if a trigger were received from input jack 10) and operate accordingly. When the input jack 1 rim is hit. m Normal operation. This event will be recognized as a signal from the input jack 1 rim. When the input jack 9 pad is hit. m This event will be recognized as a signal from the input jack 1 pad (as if a trigger were received from input jack 1) and operate accordingly. When the input jack 10 pad is hit. m This event will be recognized as a signal from the input jack 9 pad (as if a trigger were received from input jack 9) and operate accordingly. 2-3. Trigger Setup Name Changes the name of the currently selected (currently being edited) Trigger Setup. TRIG Common TrgName=Medium q q TrgName (Trigger Setup Name) Procedure 1. In the display shown above, use the [SEL] but- tons to move the cursor to the character you want to change. 2. Use the [VALUE-]/[VALUE+] buttons to select the alphabet, number or symbol. 3. Repeat steps 1 and 2 above to create the Trigger Setup name using a maximum of 8 characters. ● The available characters to choose from are (in order): space 0123456789:;?@ ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_` abcdefghijklmnopqrstuvwxyz{|}ßå 38