Yamaha DTXPRESS Owner's Manual - Page 54
Receiving Bulk Data
View all Yamaha DTXPRESS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Utility Mode 2. Select the type of bulk data (that will be sent) in the display shown above and press the [SAVE/ENT] button. The display shown below will appear. BULK all data Are you sure ? 3. Press the [SAVE/ENT] or [VALUE+] button, the bulk dump will be carried out. * Press [VALUE-] to cancel the bulk dump. When the operation is complete, the LCD will display "Complete" as shown below. BULK sssssssssss Complete ! * The device number must be set for bulk dumps [2-6. Device Number, Local Control] (P. 55) * Refer to the [MIDI Data Format] section (P. 80) for more information on bulk dump operations. Receiving Bulk Data DTXPRESS data stored in an external device can be sent back to the DTXPRESS' MIDI IN/TO HOST jack using Bulk Data Receive. 1. After reading the [Connecting a MIDI Device] (P. 12) or the [Connecting a Computer] (P. 26) section, connect the MIDI device or computer to the MIDI OUT jack/TO HOST jack on the DTXPRESS. Set the HOST SELECT switch. 2. With the sequencer (song, metronome) stopped, send bulk data from the external device. 3. When the DTXPRESS starts receiving data, the following screen will appear on the LCD. BULK Receiving Please wait... 4. When the DTXPRESS has completed receiving all the data, the following screen will appear on the LCD for a few seconds, then the screen will return to the original display (before receiving bulk data). BULK Receiving BULK Received. * Before receiving bulk data, it is necessary to match the device numbers (P. 55 [2-6]) of the DTXPRESS and the external device. It is also necessary to enable the DTXPRESS to receive exclusive messages (P. 54 [2-3]). 2-2. Channel 10 Program Change/Channel Event Receive This enables or disables the DTXPRESS to receive program change messages/channel events through MIDI channel 10. Program change messages received or transmitted through channel 10 can be used to switch DTXPRESS drum kits. It is necessary to set the receive parameter to "on" in this display in order to switch the DTXPRESS' drum kits from a song or an external MIDI device. UT MIDI RECEIVE 10PC= on 10= on q w q 10PC (Receive Program Change) This enables or disables the DTXPRESS to receive program change messages through MIDI channel 10. off: Does not receive. on: Receives. * Even if the q 10PC parameter is set to "on", program change messages from MIDI channel 10 will not be received in the following cases. • If the w 10 (receive channel event) parameter is set to "off" • If the [2-3. Receive Program Change/System Exclusive Message's] q PC (program change) parameter is set to "off". w 10 (Receive Channel Event) This enables or disables the DTXPRESS to receive MIDI channel messages through MIDI channel 10. off: Does not receive. on: Receives. 2-3. Receive Program Change/System Exclusive Messages This enables or disables the DTXPRESS to receive program change messages/system exclusive messages from all MIDI channels. UT MIDI RECEIVE PC= on SySEx= on q w q PC (Receive Program Change) off: Does not receive program change messages. on: Receives program change messages. w SySex (Receive System Exclusive Messages) off: Does not receive system exclusive messages. on: Receives system exclusive messages. 54