Yamaha DTXPRESS Owner's Manual - Page 56
Sequencer Group
View all Yamaha DTXPRESS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Utility Mode 2-8. Dump Interval This sets the length of intervals between the packets of MIDI data sent by the DTXPRESS Bulk Out function. The intervals can be adjusted to the capacity of the external receiving MIDI device to prevent data overflow. UT MIDI SETUP DumpInterval=100 q q DumpInterval (Dump Interval) [Range] 50, 100, 150, 200, 250, 300 (in msec.) 2-9. Send Hi-Hat Control This sets whether or not hi-hat controller events will be transmitted from the MIDI OUT jack or TO HOST jack. UT MIDI SETUP Send HH Ctrl= on q q Send HH Ctrl (Send Hi-Hat Control) on: Sends data to the MIDI OUT jack and TO HOST jack. off: Does not send data to the MIDI OUT jack and TO HOST jack. * This setting does not affect internal operating data for the hi-hat controller. 2-10. Host Thru Port This enables the DTXPRESS to transmit multi-port type messages received from the TO HOST jack. Only messages corresponding to the set port number will be sent via MIDI. * This setting only has affect when the TO HOST switch is set to a position other than "MIDI". UT MIDI SETUP Host Thru Port=1 q q Host Thru Port Assigns the Port Number (1-8). 3. Sequencer Group This sub-mode contains settings that relate to the sequencer (song). This group is divided into the following 8 pages. 3-1. Click Voice 56 3-2. Click Tune 57 3-3. Click Note Number 57 3-4. MIDI Control 57 3-5. Count Switch 57 3-6. Sync Mode 57 3-7. Use Tempo 58 3-8. Click Mode 58 3-1. Click Voice This function sets each of the 3 click voices used for the click sound. Drum voices are assigned. UT SEQ Click= hi q =P/053 MtBel we q Click (Click Voice) Select and set the Click Voice for the click sound. hi: Used for the click at the beginning of the measure. mid: Used for quarter note beats. lo: Used for other clicks for notes of smaller quantization. w Voice Category [Range] K, k, S, s, T, t, C, H, P, E, e, L, m Sets the voice to be used for the Click Voice selected in step q Click, select a drum voice category. Refer to Drum Kit Voice Edit Mode's [1-1. Voice] (P. 41). e Voice Number Voice Name [Range] 0, 1-127 Selects the voice that will be assigned. The Voice Number (1-127) and Voice Name will be displayed. If this parameter is set to "0", "NoAssign" will appear on the display and sound will not be produced. * Refer to the [Drum Voice List] (P. 68). 56