Yamaha DTXPRESS Owner's Manual - Page 46

Drum Kit Voice Edit Mode 4. Setup When a drum kit is selected, this function copies MIDI transmit data settings and drum kit voice settings. The Setup sub-group is divided into the following 3 pages. 4-1. Program Change, Bank Select 46 4-2. Volume, Pan 46 4-3. Drum Kit Voice Copy 46 4-1. Program Change, Bank Select When a drum kit is selected, this function sets the MIDI Program Channel Number e, the Bank Select MSB r and LSB t that will be transmitted. This can be set w for each MIDI channel q. By switching the drum kit, you can change the voice in an external MIDI device. qw KIT PC Ch 1=off PC=---M=---L=--- e r t q MIDI Channel [Range] Ch1-Ch16 w Program Change Transmit On/Off on: Transmits. off: Does not transmit. e PC (Program Change Number) [Range] 1-128 r M (Bank Select MSB) t L (Bank Select LSB) [Range] 0-127 Sets the bank for when the drum kit is switched. The bank will be assigned with the 2 values set in Bank Select MSB and LSB. * Refer to the Voice List and MIDI Data Format, etc. of the external MIDI device you are using for more information on Bank Select MSB, LSB. 4-2. Volume, Pan When a drum kit is selected, this function sets the MIDI Control Change Volume e and the Pan r that will be transmitted. This can be set w for each MIDI channel q. By switching the drum kit, you can change the voice volume and pan in an external MIDI device. qw KIT CC Ch 1=off Vol= --- Pan=--- e r q MIDI Channel [Range] Ch1-Ch16 w Control Change Transmit On/Off on: Transmits off: Does not transmit e Vol (Volume) [Range] 1-128 Sets the Volume Control Change data value that will be transmitted. r Pan [Range] 0-127 Sets the Pan Control Change data value that will be transmitted. 4-3. Drum Kit Voice Copy This function copies all data settings in [1-1. Voice] - [2-7. Pad Song] from the Input Source q to another Input Source w. KIT IN=pad 1 q CopyTo IN=pad 1 w When the Drum Kit Voice Copy operation is carried out, the Drum Kit Voice data in the destination Input Jack will be replaced with the data of the copy source. q IN (Input Source Copy Source) Sets the input source of the copy source. (Refer to P. 40) w CopyTo IN (Input Source Copy Destination) Sets the input source of the copy destination. (Refer to P. 40) Procedure 1. In the display shown above, assign the input source for the copy source and copy destination, press the [SAVE/ ENT] button. The following display will appear asking for confirmation before the copy operation is carried out. InputCpyTopad 1 Are you sure ? 2. Press the [SAVE/ENT] or [VALUE+] button, the copy operation will be carried out. * Press the [VALUE-] button to cancel the copy operation. When the copy operation is complete, "Complete!" will appear. 46