Yamaha DVD-CX1 Owners Manual - Page 33

INTRODUCTIOIN PREPARATIONS PLAYBACK 1 Main (L) Center Main (R) 1 2 1 3 1 Exit SETUP SELECT ENTER RETURN L ms C dB R 0 0 Exit Test dB SW 0 LS dB 0 ms 0 dB 0 RS Test signal Rear Subwoofer (L) 1 (L) 3 2 (R) 3 (R) 1 3 1 A B C LS LS 2 L C R SW LS RS • Center speaker Difference Approx. 50 cm (1 1/2 feet) Approx. 100 cm (3 feet) Approx. 150 cm (5 feet) Approx. 200 cm (6 feet) Setting 1.3 ms 2.6 ms 3.9 ms 5.3 ms • Rear speakers Difference Approx. 200 cm (6 feet) Approx. 400 cm (12 feet) Approx. 600 cm (18 feet) Setting 5.3 ms 10.6 ms 15.9 ms SETUP MENU I Output mode 1 Change the settings of each speaker in accordance with your speaker system. 1 Press the cursor buttons (q, w, , ) to select a speaker and press ENTER. 2 Press the cursor buttons ( , ) to select the setting and press ENTER. Example: Left surround (rear) speaker A when the speaker is not used B when using a large speaker capable of low-frequency (under 100 Hz) output. C when using a small speaker that is not capable of low-frequency output. The L and R (left and right main speakers) settings are automatically decided by the SW (subwoofer) setting. I Delay time 2 To obtain the maximum effect of Dolby Digital 5.1 channel source, all speakers should be located at the same distance from the listening position. However, in many cases they are not the center speaker is placed in line with the main speakers, etc. You can virtually increase the distance of the center and rear speakers by adjusting the delay time. 1 Press the cursor buttons (q, w, , ) to select a 'ms' box and press ENTER. 2 Press the cursor buttons ( , ) to adjust the delay time and press ENTER. I Speaker balance 3 You can adjust the output level of each effect speakers (center, surround L/R) using the test tone. 1 Press the cursor buttons (q, w, , ) to select 'Test' and press ENTER. The test tone is one speaker at a time in below order, starting with the left main speaker. L C R RS LS 2 Listening to the test tone, press the cursor buttons ( , ) to adjust the volume of effect speakers and press ENTER. The value in the 'dB' box changes. Note The subwoofer cannot output the test tone. Play something and return to this screen to adjust the output level of the subwoofer. I To exit the speaker setting mode Press the cursor buttons (q, w, , ) to select 'EXIT' and press ENTER. Notes • These adjustments are not effective on digital signal output from this unit. Make adjustments at your amplifier. • These adjustments may not be effective when the disc's original sound design is protected. PPCM indicator lights up or DMIX indicator turns off in that case. SETUP MENU APPENDIX English 29