Yamaha DVD-S2300MKII DVD-S2300MKII Manual - Page 13

CONNECTIONS PREPARATION Audio connections Select connectors that are compatible with your amplifier and appropriate for your requirements. 1 DIGITAL OUT jacks Using AV amplifier's 6.1 channel decoding (DVD-Video) and surround effects: • Connect the OPTICAL jack to the amplifier's optical digital input using fiber optic cable (not included) -or- • Connect the COAXIAL jack to the amplifier's coaxial digital input using coaxial digital cable (not included). Speakers DIGITAL INPUT AV amplifier Note • No audio signal is output from DIGITAL OUT during SACD playback. Use connection 2 or 3 below. 2 MIXED 2CH jacks Use the included audio/video pin cable to connect these jacks to analog stereo input jacks on the amplifier. Connect the white plug to the L jack. Connect the red plug to the R jack. (The yellow plug is used for the video signal.) 3 6CH DISCRETE jacks Playing SACD or DVD multi-channel audio: Use an audio pin cable (not included) to connect these jacks to the corresponding channel inputs (such as MAIN L/R, CENTER) on the amplifier (often labelled "6CH INPUT"). Connect the SUBWOOFER jack to the subwoofer input on the amplifier. This jack outputs a more natural, high-fidelity low range relative to the SUB OUT/ BASS MGMT jack explained below. However, during playback of a two-channel (stereo) source, the subwoofer does not output any sound due to lack of LFE (low-frequency effects assigned to a subwoofer). ★ SUB OUT/BASS MGMT jack When the disc you are playing has a subwoofer channel, this jack outputs the subwoofer signals. When the disc has no subwoofer channel, it outputs aggregated low ranges signals from all the other channels. Check if the speaker settings are set properly. Use an audio pin cable (not included) to connect the SUB OUT/BASS MGMT jack to the subwoofer input on the amplifier. To COAXIAL To OPTICAL To AUDIO (analog stereo input) To 6CH INPUT Either one 1 2 3 ★ Remote control in/out and RS-232C jacks Remote control in/out jacks are used in custom installations to transmit remote control signals via cable. • Connect REMOTE CONTROL IN to an output on your remote control system. • Connect REMOTE CONTROL OUT to a remote con- trol input on another component to enable system control. This unit is also equipped with RS-232C jack. Consult your dealer for details. English 9