Yamaha EL-200 Owner's Manual - Page 55
System Messages, Send the Registration Data, from the EL-200 to the Personal Computer PC
View all Yamaha EL-200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
System Messages System Exclusvei Messages System Exclusive messages are used to exchange the system and voice/ registration data. These allow you to execute bulk dump operation, sending and receiving all the data of the EL-200 including registrations to and from an external device. This is especially useful for you to build up the library of the registration data in a device like a hard disk. Examples of Exchanging the Data Use the following example to send (or receive) the registration data to (or from) a personal computer (a sequencing software). First, you need to connect your EL-200 with a personal computer (a sequencing software) using a Serial Cable or a MIDI cable. (See page 53 for more information.) NOTE: You also need a sequencing software, which has been properly installed in the personal computer, and which can send and receive system exclusive messages. Send the Registration Data from the EL-200 to the Personal Computer (PC) Preparation (Setting up registrations) 1 Set the Strings voice on the Upper Keyboard of the EL-200. Select the String voice by pressing the STRINGS button in the Upper Keyboard Voice. 2 Store the registration to the Registration Memory button 1. While holding down the M. button Press the Registration Memory button 1. Sending the Registration Data 3 Send the Request-to-Send all RAM message, "F0, 43, 70, 70, 10, F7" (Hexadecimal), from the EL-200 to the sequencing software (PC). Once the EL-200 receives the Request-to-Send all RAM message, the EL-200 automatically sends all registration data in the all registration numbers to your PC. You can store the registration data in a file on your PC. NOTE: Depending on the capacity of your sequencing software, you may need to divide the data into two and send them to the PC separately. If you want to divide, see page 61, "Data Code to Send" table. For example, by changing the message from "F0,43,70,70,10,F7" (all data) to "F0,43,70,70,17,F7," the Electone will send the Keyboard Percussion Assignment data only. Appendix 9 55