Yamaha RX-V371 Owners Manual - Page 64
Remote control, noises are heard. - model
View all Yamaha RX-V371 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
AM Problem Cause Remedy See page The desired station The signal is weak, or the antenna Adjust the AM loop antenna orientation. 21 cannot be tuned into connections are loose. Use the manual tuning method. 30 with the automatic tuning method. Automatic station Automatic station preset is not Use manual station preset. 32 preset does not available for AM stations. work. Continuous crackling and hissing noises are heard. The supplied AM loop antenna is Connect the AM loop antenna correctly 21 not connected. even if you use an outdoor antenna. The noises may be caused by lightning, fluorescent lamps, motors, thermostats, or other electrical equipment. It is difficult to completely eliminate noise, 21 but it can be reduced by installing and properly grounding an outdoor AM antenna. Buzzing and whining A TV set is being used nearby. Move this unit away from the TV set. - noises are heard. Remote control APPENDIX Troubleshooting Problem The remote control does not work or function properly. Cause Wrong distance or angle. Direct sunlight or lighting (from an inverter type of fluorescent lamp, strobe light, etc.) is striking the remote control sensor of this unit. The batteries are weak. The remote control ID of the remote control and this unit do not match. External components cannot be controlled using the remote control. The remote control code is not correctly set. Remedy The remote control will function within a maximum range of 20 ft / 6 m, and no more than 30 degrees off-axis from the front panel. Adjust the lighting angle, or reposition this unit. Replace all batteries. Match the remote control ID of this unit and the remote control. Set the remote control code correctly using "Remote control code search" on the CDROM. Try setting another code for the same manufacturer using "Remote control code search" on the CD-ROM. If this unit does not work when you press jCursor B / C / D / E (on the remote control), do the following. When the key does not work during DVD disc menu operation: press the dInput selector (on the remote control) again. When the key does not work during Option menu/Setup menu operation: press the key corresponding to the current menu operation again. Even if the remote control code is correctly set, there are some models that do not respond to the remote control. See page - - 4 56 - - - - - En 64