2008 Acura RDX Owner's Manual - Page 175

Main Menu Table Of Contents Audio System To Select a Station You can use any of five methods to find radio stations on the selected band: tune, seek, scan, the preset bars, and auto select. TUNE Use the TUNE/FOLDER bar to tune the radio to a desired frequency. Press the side of the bar to tune to a higher frequency, and the side of the bar to tune to a lower frequency. If you press and hold the or side of the bar, the frequency will begin to change rapidly. It will stop when you release it. SEEK The SEEK function searches up and down from the current frequency to find a station with a strong signal. To activate it, press the or side of the SEEK/SKIP bar, then release it. SCAN The SCAN function samples all stations with strong signals on the selected band. To activate it, press the SCAN button, then release it. You will see ''SCAN'' on the center display. The system will scan for a station with a strong signal. When it finds one, it will stop and play that station for about 10 seconds. If you do nothing, the system will then scan for the next strong station and play it for 10 seconds. When it plays a station you want to listen to, press the SCAN button again. Each side of the bars (1 Preset 6) can store one frequency on AM and two frequencies on FM. 1. Select the desired band, AM or FM. FM1 and FM2 let you store two frequencies with each side of the preset bar. 2. Use the TUNE, SEEK, or SCAN function to tune the radio to a desired station. 3. Pick the preset number (1 6), for the station you want to store. Press the left or right side of the bar, and hold it until you hear a beep. 4. Repeat steps 1 through 3 to store a total of six stations on AM and twelve stations on FM. Features CONTINUED 171 2008 RDX