2008 Acura RDX Owner's Manual - Page 196
2008 Acura RDX Manual
Page 196 highlights
Main Menu Table Of Contents Audio System The ignition switch must be in the ACCESSORY (I) or the ON (II) position. Press the AUDIO button to view the audio control display. Turn the system on by pressing the PWR/ VOL knob or the AM/FM button. Adjust the volume by turning the PWR/VOL knob. The band and frequency the radio was last tuned to are shown on the upper display. To change bands, press the AM/FM button. You can also change bands with the interface dial. Press the AUDIO button to view the audio control display and the band changes to FM1, FM2, or AM each time you push the selector up. On the FM bands, ''STEREO'' will be shown on the audio control display. ''ST'' will also appear on the upper display if the station is broadcasting in stereo. Stereo reproduction on AM is not available. XM satellite radio information is available on page 211 . To Select a Station You can use any of five methods to find radio stations on the selected band: TUNE, SEEK, SCAN, the preset buttons or icons, and AUTO SELECT. TUNE Use the TUNE/FOLDER bar to tune the radio to a desired frequency. Press the side of the bar to tune to a higher frequency, and the side of the bar to tune to a lower frequency. If you press and hold the or side of the bar, the frequency will begin to change rapidly. It will stop when you release it. TUNE ICON To tune with the interface dial, press the AUDIO button to view the audio control display, then push the selector down, and turn the dial to TUNE. Then press ENTER on the selector, and turn the dial to the desired frequency. To exit the TUNE mode, press ENTER again. 192 2008 RDX