2008 Acura RDX Owner's Manual - Page 254
2008 Acura RDX Manual
Page 254 highlights
Main Menu Table Of Contents HomeLink Universal Transceiver 4. Press and hold the button on HomeLink for 3 to 4 seconds. 5. Press the HomeLink button again for about 1 second. It should operate the garage door. Erasing Codes To erase the codes stored in all three buttons, press and hold the two outside buttons until the red indicator begins to flash, then release the buttons. You should erase all three codes before selling the vehicle. Retraining a Button If you want to retrain a programmed button for a new device, you do not have to erase all button memory. You can replace the existing memory code using this procedure: 1. Press and hold the HomeLink button to be trained until the HomeLink indicator begins to flash slowly. If a rolling code transmitter was previously programmed, the indicator will flash rapidly for 2 seconds, and then stay on for about 23 seconds. If a standard transmitter was programmed, the indicator will stay on for about 25 seconds. 2. Once the HomeLink indicator begins to flash slowly, continue to hold the HomeLink button, and follow steps 2 thru 5 under ''Training HomeLink'' (see page 248 ). 250 2008 RDX