2007 BMW X5 Owner's Manual - Page 113

The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. You can operate the device when the engine is running or when the ignition is switched on. If the device cannot be used after repeated programming, check whether the original hand-held transmitter uses an alternating-code system. To do so, either read the instructions for the original hand-held transmitter or hold down the programmed memory button 1 of the integrated universal remote control. If the LED 2 on the integrated universal remote control flashes rapidly for a short time and then remains lit for approx. 2 seconds, this indicates that the original hand-held transmitter uses an alternating-code system. In the case of an alternating-code system, program the memory buttons 1 as described at Alternating-code hand-held transmitters.< The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. Should you have questions, please contact your BMW Sports Activity Vehicle Center.< Press both outer memory buttons 1 for approx. 20 seconds until the LED 2 flashes: All stored programs are deleted. Individual programs cannot be deleted. Digital compass* Alternating-code hand-held transmitters To program the integrated universal remote control, consult the operating instructions for the equipment to be set. You will find information there on the possibilities for synchronization. When programming hand-held transmitters that employ an alternating code, please observe the following supplementary instructions: Programming will be easier with the aid of a second person.< 1. Park your vehicle within the range of the remote-controlled device. 2. Program the integrated universal remote control as described above in the section Fixed-code hand-held transmitters. 3. Locate the button on the receiver of the device to be set, e.g. on the drive unit. 4. Press the button on the receiver of the device to be set. After step 4, you have approx. 30 seconds for step 5. 5. Press the programmed memory button 1 of the integrated universal remote control three times. 1 2 Adjustment button Display The display indicates the cardinal or intercardinal direction in which you are currently driving. Operating principle You can run various functions by pressing the adjustment button with a pointed object, e.g. a ball-point pen etc. The following setting options are displayed consecutively, depending on how long the adjustment button is pressed: > Press briefly: switch display on/off > 3 to 6 seconds: set compass zone > 9 to 12 seconds: set left/right-hand drive vehicle > 12 to 15 seconds: set language > 6 to 9 seconds: calibrate compass 111 Online Edition for Part no. 01 41 0 012 501 - © 08/06 BMW AG Reference Mobility Communications Entertainment Navigation Driving tips Controls Deleting stored programs At a glance