1995 Chevrolet Suburban Owner's Manual - Page 446
1995 Chevrolet Suburban Manual
Page 446 highlights
I Maintenance Schedule II - Diesel Engines 0 Inspect shields and underhood insulation for damage or looseness. This is a Noise Emission Control Adjust or replace as required. Service. Applicable onlyto vehicles sold in the United States. I Check the air intake system installation to assure that gaskets are properly sealed and that all hose connections, fastenersand other components are tight. Also check to be sure that the air cleanerhousing is properly seated, the cover fits tightly and the wing nuts are tight. Tighten connections and fasteners or replace damaged parts as necessary. This is a Noise Emission Control Service. Applicable only to vehicles sold in the United States. 0 If your engine has a thermostatically controlled cooling fan,inspect all hoses and ducts for properhook-up (or every 12 months, whichever occurs first). Be sure the valve works properly. This is a Noise Emission Control Service. Applicable only to vehicles sold in the United States. 0 Check readfront axle fluid level and add fluid as needed. Check constant velocity joints and axle seals for leaking. ** I DATE I ACTUALMILEAGE I SERVICED BY: I 25,000 Miles (40000 km) 0 Change engine oil and filter (or every3 months, whichever occurs first). An Emission Control Service. 0 Lubricate the front suspension,king pin bushings, steering linkage, transmission shift linkage, transfer case shift linkage, parking brake cable guides, rear driveline center splines, front axle propshaft splines, brake pedal springs and clutch pedal springs. Ball joints and king pin bushings should not be lubricated unless their temperature is 10" F (-12" C), or higher. When weather is cold, let the ball joints and king pin bushings warm up before lubrication or they could be damaged. Perform each of the listed lubrication service itemsat this mileage interval (or every 12 months, whichever occurs first). (Continued) 7-83