1996 Chevrolet Camaro Owner's Manual - Page 290
1996 Chevrolet Camaro Manual
Page 290 highlights
4. Check the new headlamp again. The number on the lamp must match the number of the headlamp being replaced. The letter U or L must also match. 5. Plug the wiring connector into the headlampsocket. Snap the locking onto the socket. tabs 6. Place the new headlamp in the headlamp assembly. The socket must be pointing in the same direction the socket on the burned out bulb was. 7. Insert the tabs on the aiming ring intothe tabs in the headlamp assembly. 8. Hold the aiming ring closed, insert the screws atthe end of the ring. Tighten the screws until the aiming ring touches the plastic nuts on both the top and bottom. Do not overtighten. Do not damage the vertical aiming bubble. 3. Pull the headlampout of the assembly. Remove the wiring connector from the headlamp socketby lifting the plastic locking tabs on the connector and pulling it from the socket. 6-39