1996 Chevrolet Camaro Owner's Manual - Page 308

Using Foam-mpe Cleaner on Fabric any 1. Vacuum and brush the area to remove loose dirt. Using Solvent-Qpe Cleaner on Fabric First, see if you have to use solvent-type cleaner at all. Some spotsand stains will clean off better with just water and mild soap. If you need to use a solvent: Gently scrape excess soil from the trim material with a clean, dull knifeor scraper. Use very little cleaner, light pressure and clean cloths(preferably cheesecloth). Cleaning should start at the outside of the stain, "feathering" toward the center. Keep changing to a clean sectionof the cloth. When you clean a stain from fabric, immediately dry the area with a blow dryer to help prevent a cleaning ring. 2. Always clean a whole trim panel or section. Mask surrounding trim along stitch welt lines. or 3. Mix Multi-Purpose Powdered Cleaner following the directions on the container label. 4. Use suds only and apply with a clean sponge. 5. Don't saturate the material. 6. Don't rub it roughly. 7. As soon as you've cleanedthe section, use a sponge to remove thesuds. 8. Rinse the section with a clean, wet sponge. 9. Wipe off what's left with a slightly damp paper towel or cloth. 10. Then dry it immediately with a blow dryer. Fabric Protection Your Chevrolet has upholstery and carpet that has been treated with Scotchgard" Fabric Protector, a 3M product. It protects fabrics by repelling oil and water, which are the carriers of most stains. Evenwith this protection, you still need to clean yourupholstery and carpet often to keep it looking new. Further informationon cleaning is available by calling 1-800-433-3296 (in Minnesota, 1-800-642-6 167). 11. Wipe with a clean cloth. 6-57