1998 Chevrolet Camaro Owner's Manual - Page 88
1998 Chevrolet Camaro Manual
Page 88 highlights
'To program features, your vehicle mustbe in the programming mode. Follow these steps: 1. Put your keyin the ignition. Exit Lighting and Delayed Illumination With Exit Lighting, your interior lamps will come on for up to 25 seconds when the key removed from is the ignition. With Delayed Illumination, your interior lamps will come on and stayon for up to 25 seconds when entering the vehicle and upto 5 seconds when leaving your vehicle. Your vehicle comes with both features enabled (Mode 4). To change the factory setting,do the following: 1. Turn the courtesy lamps on by turning the instrument panel brightness control knob all the way up. 2. Count the number of chimes you hear. The number of chimes tells you which mode your vehicle set for. is 2. Turn the ignitionto RUN to disarm the Vehicle and Content Theft-DeterrentIAlarm System. 3. Turn the ignition to OFF position. 4. Remove the RADIOfuse. This fuse isin the main fuse block, located on the side of your left instrument panel. Whenthe main fuse block is open, the RADIO fuse is located in the lower right cornerside of the fuse panel. See "Fuses and Circuit Breakers" in the Index. 5. Turn the ignitionto ACC. You should hear achime to verify that the system is in programming mode. the chime sounds once, If you will be ableto program Exit Lighting, Delayed Illumination, Last Door Closed Locking and Lockout Prevention only. If the chime sounds twice and your vehicle is equipped with the Vehicle and Content Theft-Deterrent System, you willalso be able to set Keyless Entry Verification, Arming Method, Arming Verification, Driver's Door Delay and Shock Sensor Enable. 3. Turn the courtesy lamp switch to off. 4. Turn the courtesy lamp switch from on to off until you hear the number chimes that corresponds to of the mode selection you want. Mode 1: Both Off Mode 2: Delayed Illumination Only Mode 3: Exit Lighting Only Mode 4: Both On 2-20