2013 Chevrolet Corvette Owner Manual - Page 165

Instruments and Controls Read the instructions completely before attempting to program the transmitter. Because of the steps involved, it may be helpful to have another person assist with programming the transmitter. Be sure to keep the original remote control transmitter for use in other vehicles, as well as for future programming. Only the original remote control transmitter is needed for Fixed Code programming. The programmed buttons should be erased when the vehicle is sold or the lease ends. See "Erasing Universal Home Remote Buttons" in this section. Park the vehicle outside of the garage when programming a garage door. Be sure that people and objects are clear of the garage door or gate being programmed. 5-61 Programming Universal Home Remote - Rolling Code For questions or help programming the Universal Home Remote System, call 1-866-572-2728 or go to www.learcar2u.com. Most garage door openers sold after 1996 are Rolling Code units. Programming a garage door opener involves time-sensitive actions, so read the entire procedure before starting. Otherwise, the device will time out and the procedure will have to be repeated. To program up to three devices: 1. Press START or put the vehicle in accessory mode. See Ignition Positions on page 9‑17 for additional information. Programming can only occur when the vehicle is running or in accessory mode. 2. From inside the vehicle, press the two outside buttons at the same time for one to two seconds, and immediately release them.