2013 Chevrolet Corvette Owner Manual - Page 303
2013 Chevrolet Corvette Manual
Page 303 highlights
Vehicle Care 10-43 Taillamps, Turn Signal, and Stoplamps To replace a stoplamp, taillamp/turn signal bulb: 1. Remove the screw from the top of the lamp assembly. 5. Push the new bulb in the bulb socket until it snaps into place. 6. Reinstall the lamp assembly by first lining up the tabs on the bottom of the lamp assembly with the tabs in the vehicle, then slide it in. 7. Replace the screw at the top of the lamp assembly. 4. Install the new bulb in the bulb socket. 5. Install the bulb socket by turning clockwise. License Plate Lamp To replace one of these bulbs: Back-Up Lamps { WARNING Exhaust system parts can be very hot. Do not touch them. If you do, you can be burned. 1. Reach under the rear fascia and locate the back-up lamp assembly. 2. Remove the bulb socket by turning counterclockwise and pulling straight out of the lamp assembly. 3. Pull the bulb out of the socket. 1. Remove the two screws (A) from the license plate lamp assembly (B). 2. Pull the lamp assembly down and turn the bulb socket counterclockwise and out of the lamp assembly. 3. Pull the old bulb straight out of the socket. 2. Tilt the lamp assembly toward you. 3. Turn the bulb socket one-quarter turn counterclockwise and pull it out. 4. Pull the bulb straight out to remove it from the socket.