2010 Chrysler 300 Owner Manual - Page 220
2010 Chrysler 300 Manual
Page 220 highlights
UNDERSTANDING YOUR INSTRUMENT PANEL 219 damaged, a "noFUSE" message will display in the odom- reset the oil change indicator system (after performing eter display area. For further information on fuses and the scheduled maintenance) perform the following profuse locations refer to "Fuses" in "Maintaining Your cedure: Vehicle". 1. Place the ignition switch in the RUN position. (Do CHAngE OIL not start the engine). Your vehicle is equipped with an engine oil change 2. Fully depress the accelerator pedal slowly three indicator system. The "CHAngE OIL" message will flash times within 10 seconds. in the instrument cluster odometer for approximately 12 seconds after a single chime has sounded to indicate 3. Place the ignition switch in the OFF position. the next scheduled oil change interval. The engine oil NOTE: If the indicator message illuminates when you change indicator system is duty cycle based, which start the vehicle, the oil change indicator system did not means the engine oil change interval may fluctuate reset. If necessary, repeat this procedure. dependent upon your personal driving style. On vehicles equipped with a Premium Instrument ClusUnless reset, this message will continue to display each ter, this display shows the Electronic Vehicle Information time you place the ignition switch in the RUN position. Center (EVIC) messages when the appropriate conditions To turn off the message temporarily, press and release the exist. TRIP ODOMETER button on the instrument cluster. To 4