2010 Chrysler 300 Owner Manual - Page 53

52 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE you will prefer a higher position. When you release the 4. Continue to slide the latch plate up until it clears the anchorage try to move it up and down to make sure that folded webbing. it is locked in position. Automatic Locking Retractors (ALR) Mode - If In the rear seat, move toward the center of the seat to Equipped In this mode, the shoulder belt is automatically preposition the belt away from your neck. locked. The belt will still retract to remove any slack in Lap/Shoulder Belt Untwisting Procedure the shoulder belt. The Automatic Locking Mode is availUse the following procedure to untwist a twisted lap/ able on all passenger-seating positions with a combinashoulder belt. tion lap/shoulder belt. 1. Position the latch plate as close as possible to the When To Use The Automatic Locking Mode anchor point. Use the Automatic Locking Mode anytime a child safety 2. At about 6 to 12 in (15 to 30 cm) above the latch plate, seat is installed in a seating position that has a belt with grasp and twist the belt webbing 180 degrees to create a this feature. Children 12 years old and younger should always be properly restrained in the rear seat. fold that begins immediately above the latch plate. 3. Slide the latch plate upward over the folded webbing. How To Engage The Automatic Locking Mode The folded webbing must enter the slot at the top of the 1. Buckle the combination lap and shoulder belt. latch plate.