2011 Chrysler Town & Country Owner Manual - Page 180

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 177 of the lever to the second detent and hold while spray is desired. If the lever is pushed while on the intermittent setting, the wipers will turn on and operate for several wipe cycles after the lever is released, and then resume the intermittent interval previously selected. If the lever is pushed while the wipers are in the off position, the wipers will operate several wipe cycles, then turn off. NOTE: If the vehicle is moving less than 10 mph (16 km/h), delay times will be doubled. Rear Wiper And Washer Rotating the rotary ring to the first detent activates the rear intermittent wipers. To activate the washers, rotate the rotary ring fully forward and the washers will spray until the ring is released, and then resume the intermittent interval. 3 Intermittent, Low And High Speed Wipers Rotate the end of the lever to one of the first five detent NOTE: Rear window wipers function in the intermittent positions for intermittent wiper operation, the sixth dewiper speed only. tent for low wiper operation and the seventh detent for high wiper operation. WARNING! Use one of the five intermittent wiper settings when weather conditions make a single wiping cycle, with a variable delay between cycles, desirable. At driving speeds above 10 mph (16 km/h), the delay can be regulated from a maximum of approximately 18 second between cycles (first detent), to a cycle every one second (fifth detent). Sudden loss of visibility through the windshield could lead to a collision. You might not see other vehicles or other obstacles. To avoid sudden icing of the windshield during freezing weather, warm the windshield with defroster before and during windshield washer use.