2011 Chrysler Town & Country Owner Manual - Page 259

256 UNDERSTANDING YOUR INSTRUMENT PANEL CHAngE OIL LoW tirE When the appropriate condition exists, the odometer Your vehicle is equipped with an engine oil change display will toggle between LoW and tirE for three cycles. indicator system. The CHAngE OIL message will flash in the instrument cluster odometer for approximately gASCAP 12 seconds, after a single chime has sounded, to indicate If the vehicle diagnostic system determines that the fuel the next scheduled oil change interval. The engine oil filler cap is loose, improperly installed, or damaged, a change indicator system is duty cycle-based, which "gASCAP" message will display in the odometer display means the engine oil change interval may fluctuate area. Tighten the fuel filler cap properly and press the dependent upon your personal driving style. TRIP ODOMETER button to turn off the message. If the problem continues, the message will appear the next time Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN the vehicle is started. position. To turn off the message temporarily, press and noFUSE release the Trip / Odometer Display reset button on the If the vehicle diagnostic system determines that the instrument cluster. To reset the oil change indicator Ignition Off Draw (IOD) fuse is improperly installed, or system (after performing the scheduled maintenance), damaged, a "noFUSE" message will display in the odomperform the following steps. eter display area. For further information on fuses and fuse locations refer to "Fuses" in "Maintaining Your 1. Turn the ignition switch to the ON/RUN position (do not start the engine). Vehicle".