2014 Chrysler 300 Owner Manual SRT - Page 269

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 267 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. 3. Continue to press and hold the HomeLink® button, while you press and release ("cycle"), your hand-held transmitter every two seconds until HomeLink® has successfully accepted the frequency signal. The indicator light will flash slowly and then rapidly when fully trained. • To program the two remaining HomeLink® buttons, repeat each step for each remaining button. DO NOT erase the channels. If you unplugged the garage door opener/device for programming, plug it back in at this time. Reprogramming A Single HomeLink® Button To reprogram a channel that has been previously trained, follow these steps: 3 4. Watch for the HomeLink® indicator to change flash 1. Cycle the ignition to the ON/RUN position. rates. When it changes, it is programmed. It may take 2. Press and hold the desired HomeLink® button until up to 30 seconds or longer in rare cases. The garage the indicator light begins to flash after 20 seconds. Do door may open and close while you are programming. not release the button. 5. Press and hold the programmed HomeLink® button 3. Without releasing the button proceed with and observe the indicator light. "Canadian/Gate Operator Programming" step 2 and • If the indicator light stays on constantly, programfollow all remaining steps. ming is complete and the garage door/device should activate when the HomeLink® button is pressed.