2014 Chrysler 300 Owner Manual SRT - Page 96

94 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE strap. Refer to "Installing Child Restraints Using The If the belt still cannot be tightened after you shorten the Top Tether Anchorage" for directions to attach a tether buckle, disconnect the latch plate from the buckle, turn the buckle around one half turn, and insert the latch plate anchor. into the buckle again. If you still cannot make the child 6. Test that the child restraint is installed tightly by restraint installation tight, try a different seating position. pulling back and forth on the child seat at the belt path. It should not move more than 1 inch (25 mm) in Installing Child Restraints Using The Top Tether Anchorage any direction. Any seat belt system will loosen with time, so check the belt occasionally, and pull it tight if necessary. If the buckle or the cinching latch plate is too close to the belt path opening of the child restraint, you may have trouble tightening the seat belt. If this happens, disconnect the latch plate from the buckle and twist the short buckle-end belt up to three full turns to shorten it. Insert the latch plate into the buckle with the release button facing out, away from the child restraint. Repeat steps 4 to 6, above, to complete the installation of the child restraint. 1. Look behind the seating position where you plan to install the child restraint to find the tether anchorage. You may need to move the seat forward to provide better access to the tether anchorage. If there is no top tether anchorage for that seating position, move the child restraint to another position in the vehicle if one is available.