2014 Chrysler 300 Owner Manual SRT - Page 528

526 MAINTAINING YOUR VEHICLE 6. Install the bulb and connector assembly straight into 5. Pull the tail lamp assembly away from the vehicle enough to access the electrical connector. the lamp until it locks in place. 7. Install the turn signal bulb cap in the headlamp 6. housing and rotate clockwise to lock in place. 7. Rear Backup Lamp And Turn Signal Lamps 8. 1. Open the trunk. Push the electrical connector locking tab to the side. Disconnect the electrical connector. Continue removing lamp from vehicle in order to access the bulb(s). 2. Remove the trunk trim by removing the grocery hook 9. Turn the appropriate bulb and socket assembly coun(using a T-20 torque driver or similar tool), remove the terclockwise to remove it from the tail lamp assembly. fastener, and pull back the weather strip. 10. Disconnect the bulb from the socket assembly and 3. Pull back the trunk liner to gain access to the tail lamp install the replacement bulb. wing nuts. 11. Reinstall the bulb and socket assembly into the tail lamp assembly, and then turn it clockwise. 4. Remove the three wing nuts from the back of the tail lamp assembly.