2012 Ford Explorer Owner Guide 2nd Printing - Page 114

Driver Controls 3. Return to your vehicle. Press and hold the Car2U௡ system button you would like to use to control the garage door. You may need to hold the button from 5-20 seconds, during which time the selected button indicator light will blink slowly. Immediately (within 1 second) release the button once the garage door moves. When the button is released, the indicator light will begin to blink rapidly until programming is complete. 4. Press and release the button again. The garage door should move, confirming that programming is successful. If your garage door does not operate, repeat the previous steps in this section. After successful programming, you will be able to operate your Car2U௡ system by pressing the button you programmed to activate the opener. The indicator light above the selected button will turn on to confirm that the Car2U௡ system is responding to the button command. To program another rolling code device such as an additional garage door opener, a security device or home lighting, repeat Steps 1 through 4 substituting a different function button in Step 3 than what you used for the garage door opener. For example, you could assign the left-most button to the garage door, the center button to a security device, and the right-most button to another garage door opener. Note: The Car2U௡ system allows for three devices to be programmed. If you need to change or replace any of the three devices after it has been initially programmed, it is necessary to erase the current settings using the Erasing the Car2U௡ Home Automation System buttons procedure and then programming all of the devices being used. Fixed code programming Note: Do not program the Car2U௡ system with the vehicle in the garage. Make sure that your key is on and engine off while programming the transmitter. 114 2012 Explorer (exp) Owners Guide, 2nd Printing USA (fus)