2012 Ford Explorer Owner Guide 2nd Printing - Page 141

Locks and Security 2. Remove the old battery. Note: Please refer to local regulations when disposing of transmitter batteries. 3. Insert the new battery. Refer to the instructions inside the IA key for the correct orientation of the battery. Press the battery down to ensure that the battery is fully seated in the battery housing cavity. 4. Snap the battery cover back onto the transmitter and install the backup key. Note: Replacement of the battery will not cause the IKT or IA key to become de-programmed from your vehicle. They should operate normally after battery replacement. Replacing lost intelligent access keys (IA keys) If you would like to have your IA keys reprogrammed because you lost one, or would like to buy additional transmitters you can either reprogram them yourself, or take all transmitters to your authorized dealer for reprogramming. How to reprogram your intelligent access keys (IA keys) To program new IA keys yourself, refer to SecuriLock௡ passive anti-theft system in this chapter. Note: At least two already programmed transmitters are required to perform this procedure yourself. Illuminated entry The interior lamps, parking lamps and puddle lamps (if equipped) illuminate when the integrated keyhead transmitter, intelligent access keys or the keyless entry system keypad is used to unlock the door(s). The illuminated entry system will turn off the lights if: • the ignition is turned on, or control on the transmitter is pressed, or • the • the vehicle is locked using the keyless entry keypad, or • after 25 seconds of illumination. The lights will not turn off if: • they have been turned on with the dimmer control, or • any door is open. 141 2012 Explorer (exp) Owners Guide, 2nd Printing USA (fus)