2012 Ford Explorer Owner Guide 2nd Printing - Page 116

Driver Controls 5. Press and hold the Car2U௡ system button you would like to use to control the garage door. Immediately (within 1 second) release the button once the garage door moves. During this time the selected button indicator light will blink slowly. Do not release the button until you see the garage door move. Most garage doors open quickly. You may need to hold the button from 5-55 seconds before observing movement of the garage door. 6. The indicator light will (begin to) blink rapidly until programming is complete. If your garage door opener does not operate following these steps, repeat Steps 2 through 6. Otherwise, call the toll-free Car2U௡ help line at 1-866-57Car2U (1-866-572-2728). After successful programming, you will be able to operate your Car2U௡ system by pressing the button you programmed to activate the opener. The indicator light above the selected button will turn on to confirm that the Car2U௡ system is responding to the button command. Erasing the Car2Uா Home Automation System buttons Note: The system allows for three devices to be programmed. If you need to change or replace any of the three devices after it has been initially programmed, it will be necessary to erase the current settings using the procedure below and then reprogramming all of the devices being used. To erase programming on the Car2U௡ system (individual buttons cannot be erased), use the following procedure: 1. Firmly press the two outside Car2U௡ system buttons simultaneously for approximately 20 seconds until the indicator lights begin to blink rapidly. The indicator lights are located directly above the buttons. 2. Once the indicator lights begin to blink, release your fingers from the buttons. The codes for all buttons are erased. If you sell your vehicle equipped with the Car2U௡ system, it is recommended that you erase the programming for security reasons. 116 2012 Explorer (exp) Owners Guide, 2nd Printing USA (fus)