2012 Ford Explorer Owner Guide 2nd Printing - Page 115

Driver Controls 1. To program units with fixed code DIP switches, you will need the garage door hand-held transmitter, paper and a pen or pencil. 2. Open the battery cover and record the switch settings from left to right for all 8 to 12 switches. Use the figure below: When a switch is in the up, on, or + position, circle "L." When a switch is in the middle, neutral, or 0 position, circle "M." When a switch is in the down, off, or - position, circle "R." Switch position 1 2 3 Up, on or + L L L Middle, neutral M M M or 0 Down, off or - R R R L=left; M=middle; R=right 4 L M R 5 L M R 6 L M R 7 L M R 8 L M R 9 L M R 10 L M R 11 L M R 12 L M R 3. To input these positions into the Car2U௡ system, simultaneously press all three Car2U௡ system buttons for a few seconds and then release to put the device into programming mode. The indicator lights will blink slowly. Within 2.5 minutes enter your corresponding DIP switch settings from left to right into your Car2U௡ system by pressing and releasing the buttons corresponding to the settings you circled. 4. After inputting switch settings, simultaneously press and release all three Car2U௡ system buttons. The indicator lights will turn on. 115 2012 Explorer (exp) Owners Guide, 2nd Printing USA (fus)