2005 Honda CR-V Owner's Manual - Page 117

Playing a CD To Play a CD To load or play CDs, the ignition switch must be in the ACCESSORY (I) or ON(II) position. You operate the CD player/CD changer with the same controls used for the radio. To select the CD player/CD changer, press the CD button. The number of the track playing is shown in the display. With the in-dash CD changer, the disc and track numbers are displayed. The system will continuously play a CD until you change modes. LX model Loading CDs in the In-dash CD Changer Except for LX model Do not use discs with adhesive labels. The label can curl up and cause the disc to jam in the unit. To play the radio when a CD is playing, press the AM or FM button. Press the CD button again to switch back to the CD player. To play the tape when a CD is playing, insert a tape in the player. If a tape is in the player, press the TAPE button. Press the CD button again to switch back to the CD player. If you turn the system off while a CD is playing, either with the PWR/VOL knob or by turning off the ignition, the disc will stay in the drive. When you turn the system back on, the CD will begin playing where it left off. Your vehicle's in-dash CD changer hold up to six discs. 1. Press the LOAD button until you hear a beep and see ''LOAD'' in the display. To load only one CD, press and release the LOAD button. 2. The disc number for an empty position is highlighted. 3. Insert the disc into the CD slot when the green CD load indicator comes on. Insert it only about halfway; the drive will pull it in the rest of the way. You will see ''BUSY'' in the display while the CD load indicator turns red and blinks as the CD is loaded. You cannot load and play 3-inch (8-cm) discs in this system. Insert a CD into the CD slot. The drive will pull the CD in the rest of the way to play it. When the system reaches the end of the disc, it will return to the beginning and play the disc again. You can also play 3-inch (8-cm) discs without using an adapter ring. 114