2005 Honda CR-V Owner's Manual - Page 90
2005 Honda CR-V Manual
Page 90 highlights
Power Windows have children in the vehicle so they do not injure themselves by operating the windows unintentionally. AUTO REVERSE If the driver's window senses any obstacle while it is closing automatically, it will reverse direction and then stop. To close the window, remove the obstacle, then use the window switch again. Auto reverse stops sensing when the window is almost closed. You should always check that all passengers and objects are away from the window before closing it. If your vehicle's battery is disconnected or goes dead, or the driver's window fuse is removed, the AUTO function will be disabled. The power window system needs to be reset after reconnecting the battery or installing the fuse. 1. Start the engine. Push down and hold the driver's window switch until the window is fully open. 2. Pull and hold the driver's window switch to close the window completely, then hold the switch for a second or two more. If the power windows do not operate properly after resetting, have your vehicle checked by your dealer. Closing a power window on someone's hands or fingers can cause serious injury. Make sure your passengers are away from the windows before closing them. AUTO To open or close the driver's window, push or pull the window switch firmly down or up to the second detent, and release it. The window will automatically go up or down all the way. To stop the window, pull or push on the window switch briefly. When you push the MAIN switch in, the switch is OFF, and the passenger windows cannot be raised or lowered. To cancel this feature, push on the switch again to get it to pop out. Keep the MAIN switch off when you Instruments and Controls 87