2010 Honda Ridgeline Owner's Manual - Page 186
2010 Honda Ridgeline Manual
Page 186 highlights
CD Changer (Models without navigation system) On RTS, RTL, and Canadian EX-L models without navigation system Loading Discs To Play a Disc To load or play discs, the ignition switch must be in the ACCESSORY (I) or ON (II) position. You operate the disc changer with the same controls used for the radio. To select the disc changer, press the CD or CD/AUX button. You will see ''CD'' in the display. The disc and track numbers, and the elapsed time are shown in the display. You can also select the displayed information with the DISP button (see page 183 ). The system will continuously play a disc until you change modes. Your vehicle's in-dash disc changer holds up to six discs. 1. Press and hold the LOAD button until you hear a beep and see ''LOAD'' in the display, then release the button. To load only one CD, press and release the LOAD button. 2. On the upper right side of the display, the disc number for an empty position will begin blinking, and the green CD load indicator will come on. 3. Insert a CD into the CD slot. Insert it only about halfway; the drive will pull it in the rest of the way. You will see ''BUSY'' in the display. The CD load indicator turns red and blinks as the CD is loaded. You cannot load and play 3-inch (8-cm) discs in this system. 4. When ''LOAD'' appears again on the display, insert the next CD into the CD slot. Do not try to insert a disc until ''LOAD'' appears. You could damage the audio unit. 5. Repeat this until all six positions are loaded. The system will then begin playing the last CD loaded. Do not use discs with adhesive labels. The label can curl up and cause the disc to jam in the unit. 182 2010 Ridgeline