2010 Honda Ridgeline Owner's Manual - Page 70

Instrument Panel Indicators Anti-lock Brake System (ABS) Indicator This indicator normally comes on for a few seconds when you turn the ignition switch to the ON (II) position, and when the ignition switch is turned to the START (III) position. If it comes on at any other time, there is a problem with the ABS. If this happens, have your vehicle checked at a dealer. With the indicator on, your vehicle still has normal braking ability but no antilock brakes. For more information, see page 289 . On models with navigation system Immobilizer System Indicator This indicator comes on for a few seconds when you turn the ignition switch to the ON (II) position. It will go off if you have inserted a properly coded ignition key. If it is not a properly coded key, the indicator will blink and the engine will not start (see page 101 ). This indicator also blinks several times when you turn the ignition switch from the ON (II) position to the ACCESSORY (I) or LOCK (0) position. Turn Signal and Hazard Warning Indicators The left or right turn signal indicator blinks when you signal a lane change or turn. If an indicator does not blink or blinks rapidly, it usually means one of the turn signal bulbs is burned out (see pages 338 and 340 ). Replace the bulb as soon as possible, since other drivers cannot see that you are signaling. When you press the hazard warning button, both turn signal indicators and all turn signals on the outside of the vehicle flash. You will also see a ''CHECK ABS SYSTEM'' message on the multiinformation display (see page 91 ). 66 2010 Ridgeline