2008 Jeep Liberty Owner's Manual - Page 148
2008 Jeep Liberty Manual
Page 148 highlights
148 UNDERSTANDING THE FEATURES OF YOUR VEHICLE WARNING! Leaving the Electronic Speed Control system on when not in use is dangerous. You could accidentally set the system or cause it to go faster than you want. You could lose control and have an accident. Always leave the system OFF when you are not using it. To Set At A Desired Speed: When the vehicle reaches the speed desired, press down on the lever and release ("SET DECEL"). Release the accelerator and the vehicle will operate at the selected speed. NOTE: • The vehicle must be traveling at least 25 mph (40 km/h) for the speed control to set. • The vehicle should be traveling at a steady speed and on level ground before pressing the lever ("SET DECEL"). To Deactivate: A soft tap on the brake pedal, or pulling the speed control lever toward you ("CANCEL"), or normal brake or clutch pressure while slowing the vehicle will deactivate the speed control without erasing the set speed from memory. Pressing the (ON/OFF) button or turning off the ignition erases the set speed from memory. NOTE: For vehicles equipped with a manual transmission, depressing the clutch pedal will disengage the speed control. A slight increase in engine RPM before the speed control disengages is normal.