2008 Jeep Liberty Owner's Manual - Page 298
2008 Jeep Liberty Manual
Page 298 highlights
298 STARTING AND OPERATING original position, make certain all shift requirements have been met, wait five (5) seconds, and try the shift again. • The ignition switch must be in the ON position for a shift to take place and for the position indicator lights to be operable. If the ignition switch is not in the ON position, then the shift will not take place and no position indicator lights will be on or flashing. MP3022 Selec-Trac II Transfer Case - If Equipped Operating Information & Precautions The Selec-Trac II active on-demand transfer case provides four positions: • 2 (rear) wheel drive high range. • 4-wheel drive auto high range. • Neutral. • 4-wheel drive low range. This transfer case is intended to be driven in either the 2-wheel drive position (2WD) or the 4-wheel drive Auto position (4WD Auto) for normal street and highway conditions such as dry hard surfaced roads. For added capability when traversing steep grades, rough terrain, or extremely poor traction surfaces, select the transfer case 4WD Low position. This position locks the front driveshaft and rear driveshaft together and forces the front and rear wheels to rotate at the same speed while multiplying engine torque. Use the transfer case Neutral (N) position for recreational towing only. Refer to "Recreational Towing" in this section for specific procedures on shifting into and out of Neutral (N).