2008 Jeep Liberty Owner's Manual - Page 382
2008 Jeep Liberty Manual
Page 382 highlights
382 STARTING AND OPERATING indicator light turns off (approximately 1 second). After the Neutral (N) button is released, the transfer case will shift to the position identified by the selector switch. 8. Start the engine. 9. Shift the transmission into "D" (Drive) (automatic transmission) or into 1st gear and momentarily release the clutch (manual transmission) to verify that the transfer case has engaged. 10. Set the parking brake. 11. Shift the transmission into "P" (Park) (automatic transmission), or into "N" (Neutral) (manual transmission). NOTE: • Steps 1 through 6 are requirements for shifting the transfer case. If these requirements not met prior to depressing the Neutral (N) selection button or while the shift attempt is in process, then all of the mode position indicator lights will flash continuously until all requirements are met or until the Neutral (N) button is released. • The ignition switch must be in the ON position for a shift to take place and for the position indicator lights to be operable. If the ignition switch in not in the ON position, the shift will not take place and no position indicator lights will be on or flashing. • Flashing Neutral (N) position indicator light indicates that shift requirements have not been met.