2008 Jeep Liberty Owner's Manual - Page 196

196 INSTRUMENT PANEL AND CONTROLS 16. 4 LOW Mode Indicator Light - If Equipped This light alerts the driver that the vehicle is in the 4WD LOW mode. In this mode, the front driveshaft and rear driveshaft are mechanically locked together forcing the front and rear wheels to rotate at the same speed. (See page 292 for more information.) 17. Hill Descent Control Indicator Light - If Equipped The symbol indicates the status of the Hill Decent Control (HDC) feature. The lamp will be on solid when HDC is armed. HDC can only be armed when the transfer case is in the "4WD Low" position and the vehicle speed is less then 30 mph. If these conditions are not met while attempting to use the HDC feature, the HDC indicator lamp will flash on/off.(See page 314 for more information.) 18. TOW / HAUL Indicator Light - If Equipped This light will illuminate when selecting TOW/HAUL. The TOW/HAUL button is located on the gearshift bezel. (See page 281 for more information.) 19. 4WD Indicator Light - Vehicles Equipped with Command-Trac This light alerts the driver that the vehicle is in the four-wheel drive mode. In this mode, the front driveshaft and rear driveshaft are mechanically locked together forcing the front and rear wheels to rotate at the same speed. (See page 292 for more information.) 20. Electronic Stability Program (ESP) / Brake Assist System (BAS) Malfunction Indicator Light - If Equipped The malfunction indicator lamp for the ESP is combined with the BAS indicator. The yellow "ESP/BAS Warning Lamp" in the instrument