2008 Jeep Liberty Owner's Manual - Page 301

STARTING AND OPERATING 301 Interlocking Ignition System" under "Manual Transmission" or to "Starting Procedures" in this section for details. N Neutral - Disengages both the front driveshaft and rear driveshaft from the powertrain. To be used for flat towing behind another vehicle. Refer to "Recreational Towing" in this section for more information. Transfer Case Position Indicator Lights The 4WD indicator lights are located in the instrument cluster. The "N" (Neutral) indicator light is located on the 4WD Control Switch. If there is no indicator light on or flashing, the transfer case position is 2-wheel drive (2WD). If the indicator light is on, the desired position (4WD AUTO, 4WD LOW, or NEUTRAL) has been obtained. If One or More Shift Requirements are not met: • An indicator light will flash. • The transfer case will not shift. NOTE: The "SERV 4WD" warning light monitors the electric shift 4WD system. If this light remains on after engine start up, or it illuminates during driving, it means that the 4WD system is not functioning properly and that service is required. Shifting Procedures NOTE: If any of the requirements to select a new transfer case position have not been met, the transfer case will not shift, the indicator light for the previous position will remain ON, and the newly selected position indicator light will continue to flash until all the requirements for the selected position have been met. To retry a shift, move the 4WD Control Switch back to the original 5